Getting Started

This page will guide you to add Wi-Fi cabability to your platform using the HDG200 SiP module. The required steps depend on which level of platform support that is currently provided by H&D Wireless.

Conceptually, the linux driver could be used on any host platform that supports Linux, however the testing has been focused on the Atmel SAMA5 development kits and the MCIMX6Q-SDB SABRE Board for Smart Devices (imx6qsabresd).

The owl device driver implements and reuses tools and interfaces that are de-facto standard in Linux systems. Therefore, most information presented here can also be found in manual pages and from various web resources. However, the purpose of this site is to act as a quick start for evaluating the HD Wireless Wi-Fi device and to highlight any extensions or limitations specific to this driver.

The following options will be described in more detail:


Add Wi-Fi support to a custom linux-based platform

If you want to add Wi-Fi support to a custom linux-based platform using a kernel version 2.6.23 or later, you should perform the following steps:

  1. Get the SPB200 Wi-Fi device, see http://www.hd-wireless.se
  2. Download the Wi-Fi driver source code and libraries from Download and Build
  3. Build and install the Wi-Fi driver according to Download and Build
  4. Use the Wi-Fi driver according to UseDriversHDG200

Add Wi-Fi support to a supported platform

If you want to add Wi-Fi support to a platform that is listed in the Platforms topic, the build and install of the Wi-Fi driver is usually integrated into the build procedure that is used for that particular platform, e.g. OpenEmbedded.

Any special steps needed (e.g. kernel patches) for these platforms will be described in the Platforms topic and the Wi-Fi driver has also been tested in those particular environments.

However, note that it still possible to build and install the driver the "manual" way on these platforms.

Perform the following steps to add Wi-Fi support to a supported platform:

  1. Get the SPB200 Wi-Fi device, see http://www.hd-wireless.se
  2. Following the description for the particular platform, according to Platforms
  3. Use the Wi-Fi driver according to UseDriversHDG200

Add Wi-Fi support through a demo image

Demo images are provided for supported platforms to get a Wi-Fi enabled platform up and running in no time. The demo images are pre-compiled binaries which should be flashed into the platform. The exact procedure depends on the particular platform.

To install a demo image on a supported platform, perform the following steps:

  1. Get the SPB200 Wi-Fi device, see http://www.hd-wireless.se
  2. Following the description for the particular platform, according to [[DemoHDG200][Demo Images]
Topic revision: r1 - 2016-02-23 - 12:31:20 - AndersGrahn

Log In (Admin Only)

 
This site is powered by the TWiki collaboration platformCopyright © by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback